Search:


Comp II LED Comp II SCX Black SCX Silver SCX White 60s Muscle MINI Factory Match Liquid Filled Non-Filled Direct Mount Engine Thermometers Accessories All Gauges
1" Dial (K) 1½" Dial (A) 2¼" Dial (B) 3" Dial (E) 3" Asphalt (E) 3" Bottom Mount (J) 3" Asphalt (J) 3" Adjustable (ADJ3) 5" Dial (G) 5" Adjustable (ADJ5) 5" Bottom Mount (GJ) Engine Thermometers Capillary Industrial All Thermometers
Utility, Lower Mount SS/Brass, Lower Mount SS/Brass, Center Back SS/Brass, U-Clamp SS/Brass, Panel Mount All SS, Lower Mount All SS, Panel Mount 4" All SS 4.5" Process Gauges
2" All SS (Q3) 2½" All SS (K) 2½" SS/Brass (J) 4" All SS (G) 4½" Process (MPB/SC) 6" All SS (H) All McDaniel Gauges
General Service Severe Service 63mm Severe Service 100mm Diaphragm Gauges Process Gauges All MARSH Gauges MARSH PDF Catalog
Address, Phone, Fax Request Info
Contact Us About Marshall Search Catalog FAQs Site Index

How do I stop my SCX gauge lighting from blinking?

Problem: SCX stepper motor gauge backlight blinks periodically.

Cause: Vehicle's computer sends diagnostic pulses through its lighting circuit. The diagnostic pulses interrupt the 12V supply to the gauge LED light circuit causing the gauges to blink ON/OFF periodically.

Fix: Install a 12V relay between the light circuit and the gauge lighting wire. This will isolate the diagnostic pulses and provide a steady uninterupted 12V power to the gauge lighting circuit.

Back to FAQs


About Us · Search Catalog · FAQs · Contact · Site Map · Home

©2024 Marshall Instruments, Inc.
Design: BWE, Inc.
  info@marshallinstruments.com
1-714-632-8565



  Auto Gauges Thermometers McDaniel Marsh